| |
 |
Standard Genset Features |
 |
|
| |
Generator
Set Performance |
| Voltage
Regulation |
| › |
|
Maintains voltage
output to within ±1.0%. |
| › |
|
At any power factor
between 0.8 and 1.0 |
| › |
|
At any variations
from No load to Full load |
| › |
|
At any variations
from Cold to Hot. |
| › |
|
At speed droop
variations up to 4.5%. |
|
| Frequency
Regulation |
| › |
|
Isochronous under
varying loads from no load to 100% full load when
electronic governor is fitted |
|
| Random
Frequency Variation |
| › |
|
Will not exceed
±0.25% of its mean value for constant loads
– no load to full load. |
|
| Waveform |
| › |
|
Total harmonic
distortion open circuit voltage waveform in the
order of 1.8%. Three-phase balanced load in the
order of 5.0%. |
|
| Telephone
Influence Factor (TIF) |
| › |
|
TIF better than
50 |
| › |
|
THF to BS 4999
Part 40 better than 2%. |
|
| Alternator
Temperature Rise |
|
| Radio
Interference |
| › |
|
In compliance with
BS 800 and VDE levels G and N. |
|
|
Generator
Set Options |
| Fuel
options |
|
| Exhaust
Options |
| › |
|
Exhaust Silencer
- Industrial In-Line |
| › |
|
Exhaust Bellows |
| › |
|
Exhaust Silencer
- Residential , In-Line |
| › |
|
Installation Kit
- Industrial Silencer |
| › |
|
Installation Kit
- Residential Silencer |
|
| Voltage
Connections |
| › |
|
240/416V, 230/400V,
220/380V, |
| › |
|
127/220V, 115/200V,
110/190V |
|
| Miscellaneous
Options |
| › |
|
3 pole or 4 pole
Circuit Breaker |
| › |
|
Optional Set mounted
starting batteries |
| › |
|
Coolant Heater
240V |
| › |
|
Battery Charger
240V, 5A or 10A |
| › |
|
Automatic Transfer
Switches |
| › |
|
Packing - Export
Box |
|
|
Engine
Specification |
| QSK60G4 |
| › |
|
60° Vee |
| › |
|
16-cylinder diesel
engine. |
|
| Type |
| › |
|
Water cooled, four
cycle, turbocharged and low temperature aftercooled
|
|
| Construction |
| › |
|
Two valves per
cylinder, forged stee crankshaft and connecting
rods, cast iron block. |
|
| Starting |
| › |
|
24 volt negative
earth. Battery charging alternator 35 amp on engine.
Cranking current 1800 amps at 0°C. |
|
| Fuel System |
| › |
|
24 volt fail safe
actuator. Spin-on paper element fuel filters with
fuel pump injection system with integral electronic
governor. Dual flexible fuel lines and connectors.
Standard fuel water separator. |
|
| Filters |
| › |
|
Air cleaner with
dry element. |
| › |
|
Spin-on full flow
lube oil filter. |
|
| Cooling |
| › |
|
40°C ambient
temperature standard Stone guard. Drain Tap |
|
|
Alternator
Specification |
| Type |
| › |
|
Brushless single
bearing, revolving field,pole, drip proof, screen
protected. |
| › |
|
Class H Insulation,
IP23 Protection |
| › |
|
Fully interconnected
damper winding. |
| › |
|
AC exciter and
rotating rectifier unit. |
| › |
|
Epoxy coated stator
winding. |
| › |
|
Rotor and exciter
impregnated with tropical grade insulating oil
and acid resisting polyester resin. Dynamically
balanced rotor BS 5625 grade 2.5. |
| › |
|
Sealed for life
bearings. |
| › |
|
Layer wound mechanically
wedged rotor |
|
| Exciter |
| › |
|
Triple dipped in
moisture, oil and acid resisting polyester varnish
and coated with anti-tracking varnish. |
|
| Construction |
| › |
|
Two valves per
cylinder, forged stee crankshaft and connecting
rods, cast iron block. |
|
| Output windings
with 2/3 pitch for improved harmonics and paralleling
ability. |
| Close coupled
engine/alternator for perfect alignment. |
|
Compliance
Standards |
| › |
|
To BS4999/5000
pt 99, |
| › |
|
VDE 0530, UTE5100, |
| › |
|
NEMA MG1-22, CEMA, |
| › |
|
IEC 34, CSA A22.2, |
| › |
|
AS1359, BSS 5514, |
| › |
|
ISO 3046 and ISO
8528 |
|
|
 |
|
|
| |
